Feature Overview
Adjustable Clicker
Simulates a real firearm trigger by requiring a set force to "break" before firing. Break force, pretravel, and overtravel are all fully adjustable, including reducing break force to zero.
Adjustable Trigger Sensitivity
8 sensitivity levels for both trigger stages, adjusting the pull length required to fire. No hardware modifications needed — can be changed in the field.
Selectable Firing Modes
Choose modes for short or long trigger pull: SEMI ONLY, BINARY, SEMI-AUTO, SEMI-BURST, BURST-AUTO.
Active Brake
Stops the motor after each shot to prevent unintended spring compression or overspin (double shots) in high-ROF replicas.
Precocking
Keeps the piston cocked after each shot for instant trigger response. To release the spring, hold the trigger for 2 seconds — a second shot fires without precocking, then fully brakes.
Binary Trigger
In semi-auto mode, fires on both trigger pull and release for easy double shots. (Not available for SEMI ONLY / DE Version)
Rate of Fire Reduction
Limits ROF in auto or burst mode to save ammo or improve realism.
DMR Mode
Enforces a minimum interval between shots (0.25 s, 0.5 s, 1 s, 2 s, or 3 s). Required on some fields; also useful for simulating 7.62 mm rifle recoil realistically.
Low Battery Alarm
For Li-Po/Li-Ion batteries. Audible alerts repeat every minute when voltage drops critically low. Can be toggled on/off.
DSG Mode
Optimized sector gear detection for dual sector gear setups.
Diagnostic System
Continuously monitors the replica and MOSFET, providing instant fault identification for easier troubleshooting.
Electronic Fuse
Automatically disconnects the battery on short circuit or motor blockage to protect the replica and battery.
---
All settings are programmed via selector and trigger — no tools needed, changeable in seconds even in the field. Settings are independent per selector position, allowing full customization (e.g. semi on safe, binary on auto). Compatible with any battery from 7 V to 17 V, including extreme setups.